Skylark L4-138 2.3L DOHC VIN D MFI QUAD 4 (1989)
Ignition Coil: Recalls
Service Procedure
1.
Raise hood.
2.
With the ignition in the "off" position, disconnect the negative battery cable from the battery. A memory retention device, such as Kent-Moore
tool, KS295A, may be used to retain memory functions.
3.
Do NOT disconnect the 11 pin IDI harness connector.
4.
Remove the four bolts, ignition system assembly to cam housing.
5.
Remove the ignition system assembly from the engine, turn it upside down and lay it on the engine using two bolts as "locator pins" through the
cover into the cam housing on the "rear side" of the engine to hold the ignition system assembly in place.
NOTICE:
IF BOOTS ADHERE TO SPARK PLUGS, USE TOOL J-36011 TO REMOVE BY FIRST TWISTING AND THEN PULLING UPWARD ON
RETAINERS. REINSTALL BOOTS AND RETAINERS ON IDI HOUSING SECONDARY TERMINALS, MAKING SURE THAT THE
SPARK PLUG CONNECTORS (ITEM 9 IN FIGURE 1) ARE IN PLACE. BOOTS AND RETAINERS MUST BE IN PLACE ON IDI
HOUSING SECONDARY TERMINALS PRIOR TO IGNITION SYSTEM ASSEMBLY INSTALLATION OR IGNITION SYSTEM
DAMAGE MAY RESULT.
