Skylark L4-138 2.3L DOHC VIN D MFI QUAD 4 (1989)
10.
Reinstall seal(s) (Item 14 in Figure 1) to the housing.
11.
Reinstall contact(s) (Item 13) to the housing (use petroleum jelly to retain).
12.
Install new "yellow tab" coil (s) to the cover, as required. Install coil harness connectors to both coils.
13.
Reinstall the housing (Item 7 in Figure 1) to the cover (Item 1) with four screws (Item 4); torque screws to 4 N-m (35 lb.in).
14.
Install the ignition system assembly to the engine while carefully aligning boots to the spark plug terminals.
15.
Coat the four bolts, ignition system assembly to cam housing, with P/N 1052080 sealer (or equivalent). Install the bolts through the cover to the
cam housing and torque to 20 N-m (15 lb.ft.).
NOTICE:
IF THE ABOVE BOLTS ARE NOT COATED WITH SEALER PRIOR TO REINSTALLATION, FUTURE REMOVAL OF THE BOLTS
MAY STRIP THE THREADS IN THE ALUMINUM OF THE CAM HOUSINGS.
16.
Reconnect the negative battery cable. In the interest of customer satisfaction, please advise customer that the battery was disconnected (not
required if a memory retention tool was used) and the radio and clock may need resetting.
17.
Install a Campaign Identification Label.
