Skylark L4-138 2.3L DOHC VIN D MFI QUAD 4 (1989)
6.
If there is no continuity, locate and repair open between terminal Nos. 1 and 8 in wiring harness.
7.
If there is continuity, check armature, circuit breaker, circuit breaker ground and brushes.
Blades Cycle In & Out Of Park Position When Wiper Is Off
1.
Check whether motor operates in LO.
2.
If not, refer to No LO Mode.
3.
If motor operates in LO, replace park switch. Problem may also be caused by bent drive pawl or excessive output shaft endplay.
Fig. 12 Permanent Magnet Depressed Park Type Wiper Motor w/Integral Washer Pump
