Skylark L4-138 2.3L SOHC VIN 3 MFI QUAD 4 (1992)
Drive Belt Tensioner: Service and Repair
Without A/C
Generator, A/C Compressor Or Idler Pulley, & Tensioner Bracket
Idler Pulley (Without A/C)
Remove or Disconnect
1. Negative battery cable.
2. Serpentine drive belt.
CAUTION: To avoid personal injury when rotating the serpentine belt tensioner, use a tight fitting 13 mm wrench that is at least 61 cm
(24") long.
^
This operation can be done using J 37059.
3. Generator assembly.
4. Idler pulley brace retaining bolts and brace.
5. Raise vehicle.
6. Right splash shield.
7. Chain housing to belt tensioner bracket brace.
8. Five (5) bracket to block retaining bolts.
9. Bracket out the wheel opening.
