Skylark L4-138 2.3L SOHC VIN 3 MFI QUAD 4 (1992)
2.
Loosen the inner panel cam screws (4).
3.
Loosen the front lower run channel attachment screw (5).
4.
Adjust cam (3) to fully seat window in rear run channel.
5.
Tighten inner panel attachment screws (4) to 10 N-m (89 lbs.in.).
6.
Move window down until the top is 2 inches above the bottom of the window opening.
Important:
When operating window, do not contact down stop bumper prior to tightening the front channel attachment screw to prevent the mis-location of the
window assembly.
7.
Grasp the front channel guide above screw (5) to keep retainer from twisting while fully seating front channel (1) on window. Refer to Figure 1,
Section A-A.
8.
Tighten front channel screw (5) to 10 N-m (89 lbs. in.).
9.
Cycle window assembly up and down twice to check for proper operation, seating and sealing of the window.
10.
Repeat adjustment procedure if necessary.
Parts Information: