buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Power Locks > < Keyless Entry Receiver|Locations|Page 13039
Page 1
background image

Keyless Entry Transmitter Battery: Service and Repair

Transmitter Battery Replacement

REMOVE OR DISCONNECT

1. Pry cover in groove with dime or small screwdriver.
2. Cover (leave seal in place).
3. One battery.

INSTALL OR CONNECT

1. One battery (positive side down) CR2032 (3 volt) or equivalent.
2. Cover (put seal back into position if it came out of position in Step 2 above).
3. Snap cover into place.
4. Resynchronize the transmitter. 
5. Check for proper operation.

Normal battery life is approximately two years. The batteries should be replaced when the range of the RKE transmitter begins to decrease
significantly to less than approximately 7 meters (23 feet).

Power Locks > < Keyless Entry Receiver|Locations|Page 13039