Skylark L4-144 2.4L DOHC VIN T SFI (1997)
3. With the hydraulic modulator upside down, and the gears facing you, rotate each hydraulic modulator gear counterclockwise until movement
stops. This procedure will position the pistons very close to the top of the hydraulic modulator bore, simplifying the brake bleeding procedure.
4. Position motor pack ont9 hydraulic modulator, aligning the three. motor pack gears with the modulator. Take care in handling the motor pack. If
dropped or damaged during handling, the motor pack must be replaced.
5. Four motor pack to hydraulic modulator Torx head screws. Tighten Torx head screws to 5 Nm (44 inch lbs.).
6. Gear cover onto hydraulic modulator with Torx head screws. Tighten Torx head screws to 4 Nm (36 inch lbs.).
7. Hydraulic modulator/master cylinder assembly.
