Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Electronic Brake Control Module: Service and Repair
REMOVE OR DISCONNECT
1. Engine harness connector from EBCM.
2. Hex head screws attaching EBCM to cowl panel.
3. EBCM from cowl panel. Inspect and Ensure all 3 plastic grommets are properly located.
INSTALL OR CONNECT
1. EBCM to cowl panel, aligning screw holes.
2. Hex head screws, attaching EBCM. Tighten Hex head screws to 2 Nm (17 inch lbs.).
3. EBCM electrical connector.
