Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Wheel Speed Sensor: Service and Repair
Front Wheel Speed Sensor
NOTE: Raise and support vehicle on suitable hoist.
REMOVE OR DISCONNECT
1. Front sensor electrical connector.
2. Retaining bolt.
3. Front wheel speed sensor. If sensor will not slide out of knuckle, remove brake rotor and use a blunt punch or equivalent tool to push sensor from
back side of knuckle. If sensor locating pin break off and remains in knuckle during removal, proceed as follows. Remove brake rotor and remove
broken pin using a blunt punch. Clean hole using sand paper wrapped around a screwdriver or other suitable tool. Never attempt to enlarge the
hole.
INSTALL OR CONNECT
1. Front wheel speed sensor on mounting bracket. Make sure front wheel speed sensor is properly aligned and lays flat against bosses on knuckle.
2. Retaining bolt. Tighten Retaining bolt 12 Nm (107 inch lbs.).
3. Front sensor electrical connector to front wheel speed sensor.
