Skylark L4-144 2.4L DOHC VIN T SFI (1997)
to bleed out once the lifters are installed.
24. If new lifters have been installed or the lifters bled down while the engine was disassembled, excessive lifter noise may be experienced. This is a
normal condition and no engine damage is occurring. Use the following procedure to purge air from the lifters:
a. Start the engine and allow the engine to warm up at idle for 5 minutes.
b. Increase the engine speed to 2000 RPM until the lifter noise is gone.
c. Return the engine to idle for an additional 5 minutes or perform a road test.
25. Install the electrical connector to the ignition coil and the module assembly.
26. Connect the negative battery cable.
