Skylark L4-144 2.4L DOHC VIN T SFI (1997)
15. Remove the flex plate cover stud for clearance.
16. Remove the radiator outlet pipe from the lower radiator hose and oil pan.
17. Remove the oil level sensor connector.
18. Remove the oil pan bolts.
19. Remove the oil pan.
INSTALLATION
1. Install the oil pan
2. Place the spacer in its approximate installed location but allow clearance to tighten the pan bolt directly above the spacer.
3. Tighten the oil pan bolts.
^
(1) (M8 X 1.25 X 80) 24 Nm (18 lb ft).
^
(2) (M8 X 1.25 X 22) 24 Nm (18 lb ft).
^
(3) (M6 X 1.00 X 2.5) 12 Nm (106 lb in).
^
(4) 26 Nm (19 lb ft).
4. Position the spacer into its proper location and install the stud.
5. Install the oil pan to the transmission nut.
6. Install the oil level sensor connector.
7. Install the radiator outlet pipe to the lower radiator hose and oil pan.
8. Install the exhaust manifold brace.
9. Install the radiator outlet pipes to the oil pan.
10. Install the radiator outlet pipe bolts. See Cooling System.
11. Install the engine mount strut bracket.
12. Install the transmission to the engine brace. Tighten the bolts to 50 Nm (37 lb ft) in sequence.
13. Install the A/C compressor bolts. See Heating and Air Conditioning.
14. Install the drive belt.
15. Install the right splash shield.
16. Install the right front wheel and tire assembly.
17. Install the flex plate housing or transmission converter cover. See Transmission and Drivetrain.
18. Fill the cooling system. See Cooling System.
19. Fill the crankcase with oil.
20. Connect the negative battery cable.
