Skylark L4-144 2.4L DOHC VIN T SFI (1997)
7. Using the torque angle meter, install the bolts in sequence. Tighten the bolts to 15 Nm (11 lb ft) + 90 degrees.
8. Install the timing chain housing and the timing chain.
9. Uncover the fuel injectors.
10. Install new injector O ring seals. Lubricate the O ring seals with engine oil.
11. Uncover the injector openings in the cylinder head and install the fuel rail onto the cylinder head.
12. Install the fuel rail to the camshaft housing bolts. Tighten the bolts to 26 Nm (19 lb ft).
13. Connect the fuel line retaining clamp and the retainer to the bracket on top of the camshaft housing.
14. Connect the vacuum line to the fuel pressure regulator.
15. Install the fuel injector harness connector.
16. Install the camshaft position sensor connector.
NOTE: When reinstalling the power steering pump, apply a 3 mm bead of GM P/N 12346286 sealer or equivalent to the joint at the end of the
camshaft housing halves before installation of the power steering pump and the pump face seal.
17. Install the power steering pump assembly. See Steering and Suspension.
18. Reinstall any spark plug boot connector assembly that stuck to a spark plug back onto the ignition coil and module assembly.
19. Place the ignition coil and module assembly over the spark plugs and push straight down.
20. Clean any lubricant that is present on the ignition coil and module assembly to the camshaft housing bolts.
