Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Camshaft Position Sensor: Service and Repair
REMOVE OR DISCONNECT
NOTE: Numbers in text correspond to numbered components in image.
1. Disconnect the Camshaft Position (CMP) sensor harness connector at the sensor.
2. Remove the CMP sensor bolt (2).
3. Remove the CMP sensor (1) from the camshaft housing (3).
INSTALL OR CONNECT
NOTE: Inspect sensor O-Ring for wear, cracks or leakage. Replace if necessary. Lubricate new O-Ring with engine oil before installing.
1. CMP sensor (1) into camshaft housing (3).
2. CMP sensor bolt (2) and tighten bolt to 10 Nm (88 lb. in.).
3. Sensor harness connector.