Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Figure 28
Figure 29
20. Strip 13 mm (0.5 inch) of insulation from both ends of the wires cut in the previous step.
21. Short the wires by twisting together one end of each (Figure 27). The deployment wires shall remain shorted and not connected to a power source
until you are ready to deploy the air bag.
CAUTION: When you are deploying an inflator module for disposal, perform the deployment procedures in the order listed:
^
Wear safety glasses throughout the procedures.
^
Make sure the area around the inflator module is clear of all people and loose or flammable objects.
^
Short the deployment harness wires as instructed.
^
Connect the deployment harness to the inflator module before you connect it to the power source.
^
Connect the deployment harness to the power source to immediately deploy the air bag.
Failure to follow the procedures in the order listed may result in personal injury.
22. Twist together one connector wire lead to one deployment wire. The connection must be mechanically secure (Figure 28-1).
23. Bend flat the twisted connection that you made in the previous step. Secure the connection by wrapping tightly with electrical tape. This will also
insulate the connection (Figure 28-2).
24. Twist together, bend and tape the remaining connector wire lead to the remaining deployment wire (Figure 28-3).
25. Connect the deployment harness to the inflatable restraint I/P module, yellow 2-way connector.
26. Route the deployment harness out the passenger side of the vehicle (Figure 29).
27. Be sure to clear the inside of the vehicle and the area surrounding the vehicle of any people. Clear the vehicle of all loose or flammable objects.
28. Stretch the driver and passenger deployment harnesses to their full length (Figures 25 and 29).
