Skylark L4-144 2.4L DOHC VIN T SFI (1997)
Testing Solenoid Winding
INSTALL OR CONNECT
1. Drive assembly to armature shaft as follows:
A. Lubricate area on armature shaft that will be under drive assembly lightly with GM lubricant P/N 1960954 or equivalent.
B. Drive assembly onto armature shaft with pinion away from armature.
C. Pinion stop collar onto armature shaft.
D. New pinion stop retainer ring into groove on shaft. Do not reuse old ring.
E. Thrust collar to end of shaft with flange toward retainer ring. Use pliers to snap pinion stop collar over retainer ring.
Inspect
-
Bushing (SD205) or Bearing (SD255) in drive end housing. If damaged, replace drive end housing. If dry, lubricate with GM lubricant P/N
1960954 or equivalent. Avoid excessive grease.
2. Shift lever yoke to drive collar, then armature/drive/lever assembly into drive end housing.
3. Shift lever shaft through holes in drive end housing and shift lever, then secure with retainer. Place return spring onto plunger.
4. Solenoid over plunger by depressing spring, aligning to drive end housing. Install attaching screws.
5. Frame and field assembly as follows:
