Skylark L4-144 2.4L DOHC VIN T SFI (1997)
11. Push C/V joint onto axle shaft (14) until retaining ring (17) is seated in groove on axle shaft (14).
12. Slide large diameter of seal (15) with large seal retaining clamp (16) in place over outside of C/V joint race (21) and locate seal lip in groove on
race (21).
Important: Seal (15) must not be dimpled, stretched or out of shape in any way. If seal is not shaped correctly, equalize pressure in seal (15) and
shape seal properly by hand.
13. Crimp seal retaining clamp (16) with J 35910 to 176 Nm (130 ft. lbs.).
