Skylark L4-151 2.5L (1991)
II. Fan Installation
^
Insert fan on motor shaft
-
Grasp fan by dome and by applying hand pressure to fan dome insert fan on motor shaft until fan is lightly seated on motor shaft.
-
Place fan and motor on a 13 mm x 1/2" drive socket as shown in Figure 2.
-
While steadying the fan and motor, apply steady force to the rear of the motor shaft, using a drill press or small arbor press and pin
arrangement, until the clearance between the motor mounting plate and the fan hub is 5.5 mm +/- 0.5 mm (7/32" +/- 1/32").
^
Remove the spacers (nuts) by grasping fan dome and turn fan which will dislodge spacers from under fan.
NOTICE:
Do not hammer on motor to install fan or damage to motor may occur.
-
To prevent motor shaft/bearing damage, do not apply force to motor housing to seat fan on motor.
-
To prevent fan damage during installation, do not apply pressure to fan rim.
-
It is necessary to ensure the proper replacement fan is used.
-
Seal end housing of blower motor using "water resistant" tape
(provided in motor kit).
WARRANTY INFORMATION:
Labor Operation Number:
D1322 with A/C
D1320 without A/C
Labor Time:
Engine Code N (3300)
0.4 hour
Engine Code D (2.3L)
0.4 hour
Engine Code U (2.5L)
0.5 hour
Trouble Code:
92
