Skylark V6-173 2.8L VIN W FI (1985)
Brake Warning System: All Technical Service Bulletins
Technical Procedure
INSTALLATION OF "LAMP CIRCUIT KIT" (ALL VEHICLES INVOLVED) AND "PUMP CIRCUIT" KIT (CERTAIN INVOLVED VEHICLES).
1.
Open vehicle hood and cover fenders.
2.
Disconnect negative cable from battery.
FIGURE 1 - I. P. HARNESS TO ENGINE HARNESS CONNECTOR ASSEMBLY
3.
Loosen bolt that retains engine compartment connector assembly to front of dash, and unplug engine harness part of connector from I.P. harness
connector. Remove I.P. harness connector from its mounting bracket. Refer to Figure 1.
FIGURE 2 - REMOVING I.P. HARNESS CONNECTOR SECONDARY LOCK
4.
Remove the terminal secondary lock from I.P. connector, as shown in
Figure 2.
