Skylark V6-173 2.8L VIN W FI (1985)
FIGUHE 8 - INSERTING WIRE TERMINAL REMOVED FROM CAVITY J-6 INTO FURNISHED CONNECTOR
14.
Remove the wire terminal from cavity J6 of connector. Refer to Figure 7. Raise terminal lock tang to original position. Plug the furnished single
connector onto this removed terminal and latch the connector lock. Refer to Figure 8. Plug this connector into connector of furnished jumper
harness from pump kit.
FIGURE 9 - INSERTING PUMP JUMPER HARNESS WIRES IN I. P. CONNECTOR
FIGURE 10 - PUMP CIRCUIT HARNESS JUMPER INSTALLED
15.
Plug the larger terminal on jumper harness into cavity J6 and the other terminal to cavity C3 of instrument panel connector. Refer to Figure 9 and
10.
