Skylark V6-173 2.8L VIN W FI (1985)
16.
Tape the jumper harness connector and wires to the I.P. harness so that they are covered and free from possible pinch.
17.
Reinstall connector secondary lock(s).
18.
Install the I. P. connector back into its mounting bracket, and plug engine harness and I. P. harness connector together.
19.
Install connector assembly on the dash, torquing bolt to 7 N-m (5 lbs. ft.).
20.
Connect the negative cable to the battery.
21.
Check the vacuum pump low vacuum indicator warning light operation as follows:
a.
Remove power brake check valve from booster.
b.
With park brake released, turn ignition to "on" or "run" position. Do not start engine.
-
Vacuum pump should be running.
-
Brake indicator light on instrument panel cluster should come on in 15-45 seconds.
c.
After light comes on, reinstall brake booster check valve and start engine and run at idle. Brake light should go "out" in less than ten seconds
and vacuum pump should stop operating.
22.
If vacuum pump and brake indicator light did not operate as described in step 21, locate and check system problem.
CAMPAIGN IDENTIFICATION LABEL
23.
Install a Campaign Identification Label. Each vehicle modified in accordance with the instruction outlined in this procedure will require a
Campaign Identification Label. Each label provides a space to include the campaign number, the five (5) digit dealer code of the dealer performing
the campaign service, and the date vehicle was campaigned. This information may be inserted with a typewriter or ballpoint pen. When installing
label, clean the surface of the radiator upper mounting support and apply the campaign label where it is readily visible.
