Skylark V6-173 2.8L VIN W FI (1985)
FIGURE 3 - MAIN I.P. HARNESS AND MASTER CYLINDER BRANCH
5.
Remove the tape and plastic conduit from the main I.P. harness back to a point where the brake pressure switch connector branch (to master
cylinder) leaves the main harness. Refer to Figure 3.
6.
Remove the tape and conduit from the pressure switch branch of the wiring.
7.
Cut the tan wire with white stripe at a place approximately 7 inches from the end of the pressure switch connector. Refer to Figure 3. Strip both
ends of this cut wire.
