Skylark V6-173 2.8L VIN W FI (1985)
Headlamp Switch: Service and Repair
1983---85 SKYLARK
1.
Disconnect battery ground cable.
2.
Remove headlamp switch knob by using a small screwdriver through slot to depress retainer while pulling knob out.
3.
Remove switch bezel.
4.
Remove rear window defogger switch knob, if equipped, by pulling straight off.
5.
Remove 3 attaching screws from lower edge of lefthand trim panel.
6.
Pull lefthand trim panel straight forward and remove from vehicle.
7.
Remove 2 headlamp switch attaching screws and the switch. Pulling switch straight out of dash will also disconnect the electrical connector.
8.
Reverse procedure to install.