Skylark V6-173 2.8L VIN W FI (1985)
Install or Connect
1. Rack and pinion through left wheel opening.
2. Rack and pinion mounting bolts and tighten to specifications.
3. Heat shield if equipped.
4. Raise frame and install rear frame bolts and tighten to specifications.
5. Remove stands.
6. Brackets and clips on crossmember.
7. Tie rod ends and tighten to specifications.
8. Both tire and wheel assemblies and tighten to specifications.
9. Lower car.
10. Lines at gear from pump and tighten to specifications.
11. Line retaining clips.
12. Intermediate shaft at stub shaft and tighten pinch bolt to specifications.
13. Air cleaner
14. Fill with fluid.
15. Bleed air from system.
