Skylark V6-173 2.8L VIN W FI (1985)
numbers for these packages are as follows:
PART
NUMBER
MODEL
998568
Electra
997090
Riviera
997091
LeSabre (15" x 6" wheel) - JA1
997092
LeSabre (15" x 7" wheel) - JA3/JA5
997093
Regal
997094
Skylark
997788
Century (115 mm bolt circle) - JA1
998547
Century (110 mm bolt circle) - JA2/JA3/JA8
998697
Skyhawk (13" x 5.5" wheel)
When the vehicles is being made ready for delivery, the lock brackets are to be installed prior to installation of the wire wheel cover and medallions.
1.
Raise vehicle with lift equipment.
2.
Remove three (3) special lug nuts from each wheel for lock bracket installation - refer to illustrations.
3.
Place lock bracket on lug nut studs.
4.
Reinstall three (3) special lug nuts on each wheel to retain lock bracket and torque to specifications. LOOSE CONDITION OF LOCK BRACKET
MAY BE NORMAL. WHEN LUG NUTS ARE SEATED, FRONT WHEEL STUDS WILL HAVE A RECESSED APPEARANCE, WHICH IS
NORMAL
5.
Install adapter or anti-rotation clips if required.
6.
Install wheel cover on wheel.
NOTE:
The Electra (C) models use a new lightweight center retention. wire cover. This cover relies on the center lock bracket and fastener to
hold the cover on the wheel. It is important that installation instructions for the anti-rotation clips and cover are followed.
7.
Tighten lock bolt/nut with lock key wrench.
8.
Install center medallion.
9.
Install removal instruction label as required.
10.
The lock key wrench is to be placed in the glove box along with the I.D./Registration Card.
Assembly Instructions
FOR INSTALLATION OF ANTI-ROTATION CLIPS TO FACTORY MOUNTED BRACKETS
CAUTION:
ANTI-ROTATION SPRING
CLIPS MUST BE INSTALLED PRIOR TO
INSTALLATION OF WHEEL COVER.
1985 C ANTI-ROTATION CLIP INSTALLATION
ANTI-ROTATION CLIPS SHOULD BE INSTALLED INTO FLAT AREAS OF LOCK BRACKETS. (FIG. 1).