Skylark V6-173 2.8L VIN X 2-bbl (1984)
Body Emblem: Technical Service Bulletins
Plastic Emblems and Ornaments - Replacements
Bulletin 84-1-3
Date
Nov. '83
Ref. No. 84-050-10
SUBJECT:
PLASTIC EMBLEM AND ORNAMENT REPLACEMENTS
MODELS AFFECTED: ALL 1984
When replacing plastic inserts such as the emblem in the front end panel or grill assembly, care must be taken to use the correct type of adhesive. Do not
use instant glues (cyanoacrylate) or adhesives that are not recommended for use on plastics as these will damage the plastic emblem. Use a clear silastic
or silicone rubber (R.T.V.) type of adhesive or 3M plastic and emblem adhesive #08061, or equivalent. If both surfaces to be glued have been
thoroughly cleaned, then this type of adhesive will make a good, flexible and permanent bond.
