Skylark V6-173 2.8L VIN X 2-bbl (1984)
If the noise is still present after tightening the cradle bolts, it can be corrected by installing shims on both rear cradle mount insulators, as shown in
illustration. The intent of this fix is to create an interference fit using shims. Multiple shims may be used if necessary.
Shims may be fabricated from any available steel or brass shim stock. Thickness should be approximately .025" to .040".
The following procedure should be followed when installing shims:
1.
Support cradle with a jack stand on the rear crossmember.
2.
Remove one (1) rear cradle bolt at a time and lower jack stand enough to remove pressure from the mount.
CAUTION: Damage to the steering intermediate shaft could result if the cradle is lowered more than required to free the mount.
3.
Form shim to mount as shown and reinstall mount. Some rubber lube may be required to ease assembly.
4.
Reinstall mount bolt. Torque to 85 ft.lbs. (115 N-m).
5.
Repeat above procedure on other rear corner.
Warranty Information
Labor Operation Number:
E1040
Labor Time:
.5 hours
Trouble Code:
92
