Skylark V6-173 2.8L VIN X 2-bbl (1984)
- Wiring Diagaram for Chart C-2F TPS Enrichment Check.
CHART C-2F, TPS ENRICHMENT CHECK
CHART DESCRIPTION
1.
This step checks that the TPS will cause an ECM "Rich" command when fully depressed manually. On some cars, this will cause a low dwell (full
rich). On others it will not.
Code 21 should normally be set.
2.
This step distinguishes between a faulty TPS or ECM harness/ECM.
Code 21 should normally be set, if engine RPM is not set above specifications.
3.
This step checks for 5V. ref. at TPS. It should be about 5 volts. If loss of V. Ref. were in the ECM,it should set Codes 21, 32 and 34 since this is
the same 5V to MAP, BARO or Vacuum Sensors. Therefore, it must be an open CKT416.
4.
This step checks for a grounded CKT417. Normal circuit should read about 5 volts. Checking for grounded TPS output CKT417 to Terminal "2"
of ECM,or shorted CKT417 to 452 from TPS, indicates whether fault is in wiring or ECM. A voltmeter with a 10 megohms resistance must be
used for an accurate reading.
