Skylark V6-181 3.0L (1986)
Brake Master Cylinder: Service and Repair
Master Cylinder Installation
For additional informations see Notes, Warnings, and Hints. See: Fundamentals and Basics
Removing/Installing Master Cylinder Assembly
-
Install master cylinder and attaching nuts and torque to 30 - 45 Nm (22 - 30 ft. lb.).
-
Install pushrod to brake pedal (manual master cylinder).
Failure Warning Switch
-
Install electrical connector at warning switch.
-
Install hydraulic lines and tube nuts and torque to 14 - 20 Nm (120-180 in. lb.).
-
Fill master cylinder to proper level with clean brake fluid. Proper level is between min. and max. indicator levels in opening on top reservoir.
-
Bleed hydraulic system. See: Service and Repair
-
Recheck fluid level.