Skylark V6-191 3.1L VIN M SFI (1994)
Throttle Cable/Linkage: Service and Repair
Accelerator Control - Passenger Compartment
NOTE: When performing service on the accelerator pedal, observe the following:
a.
The mounting surface between the support and dash panel must be free of insulation. The carpet in the pedal and tunnel area must be positioned to
lay flat and be free of wrinkles.
b.
Slip the accelerator control cable through the slot in the rod and then install the retainer rod, being sure it is seated. Care must be utilized in
pressing the retainer into the hole in the rod to assure the cable is not kinked or damaged in any way.
c.
After securing, all components of the accelerator linkage must operate freely without bind between full-closed throttle and wide-open throttle.
d.
Wires, hoses, cables or other obstructions must not be placed within 13mm (1/2 inch) of cable or rod at any point in their travel.
Throttle And Cruise Control Cable Installation
