Skylark V6-204 3.3L VIN N FI (1989)
3. Install or connect strut to steering knuckle and install bolts finger tight.
4. Grasp top of tire firmly, then move tire inboard or outboard until correct camber reading is obtained. Tighten retaining bolts enough to secure
camber setting.
5. Remove wheel and tire assembly, if necessary, then tighten strut to steering knuckle retaining bolts.
-
On 1989-90 models, torque strut to steering knuckle retaining bolts to 135 ft. lbs.
-
On 1991-92 models, torque strut to steering knuckle retaining bolts to 133 ft. lbs.
Front Toe Adjustment
Toe, Fig.1 , is controlled by tie rod position. Adjustment is made by loosening the clamp bolts at the steering knuckle end of the tie rods and rotating
the rods to obtain proper toe setting, Fig.3 . After correct toe setting is obtained, torque clamp bolts to 41 ft. lbs.
