Skylark V6-3100 3.1L VIN M SFI (1996)
Power Mirror Switch: Technical Service Bulletins
Mirror Switch Bezel - Remove/Install Procedures
File In Section: 10 - Body
Bulletin No.: 53-10-24A
Date: February, 1996
SERVICE MANUAL UPDATE
Subject:
Section 10-6 - Add Remove/Install Procedure for Mirror Switch Bezel
Models:
1996 Buick Skylark
1996 Oldsmobile Achieva
1996 Pontiac Grand Am
This bulletin is being revised to update Step 1 of the "Remove or Disconnect" procedure. Please discard Corporate Bulletin Number 53-10-24 (Section
10 - Body).
Please add the following procedure to Section 10-6 of the Service Manual.
Mirror Switch Bezel
Remove or Disconnect
1.
Buick & Oldsmobile - Front left door power lock and window switch bezel by engaging a small flat blade screwdriver to spring clip under rear of
bezel.
Pontiac - Front door power lock and window switch bezel by prying under rear edge of the bezel after two screws are removed.
2.
Wire harness connectors.
3.
At front door power lock and window switch opening, reach inside opening of door trim panel and disengage mirror switch from bezel by pulling
on base of mirror switch.
4.
Push on base of bezel to disconnect from door trim panel.
Install or Connect
1.
Align keyway on bezel to door trim panel and push to engage bezel.
2.
At front door power lock and window switch opening, reach inside opening of door trim panel and align keyway on mirror switch to bezel, then
grasp mirror switch handle and pull toward bezel until it snaps in place.
3.
Wire harness connectors.
4.
Front door power lock and window switch bezel by inserting clips and snap into place.