Skylark V6-3100 3.1L VIN M SFI (1996)
used when the customer demands quicker repair of the vehicle than the above described one-part product can provide.
This two-part, chemical cure product requires ONE (1) TO ONE-AND-ONE-HALF (1-1/2) HOURS FOR CURING BEFORE RETURNING THE
VEHICLE TO THE CUSTOMER. This two-part product also requires primers on the glass and pinchweld surfaces. The primers and applicator daubers
are not included with this two-part product and therefore, must be purchased separately. In addition, this two-part product requires a special applicator
(gun) for proper mixing and dispensing of the adhesive.
Important:
The U216 product is NOT available from GMSPO and must be obtained locally.
*
We believe this source and their products to be reliable. There may be additional manufacturers of such products. General Motors does not endorse,
indicate any preference for or assume any responsibility for the products from this firm or for any such products which may be available from other
sources.
When using either of the above described products, make sure to follow the manufacturer's directions for application and drying times. For information
regarding the removal and installation of stationary glass, consult the appropriate Service Manual.
Parts information
P/N
Description
12346392
Urethane Adhesive Caulking Kit
Parts are expected to be available from GMSPO, 10/12/98.
Important:
The previously recommended adhesive kit (P/N 12346284) will no longer be available from GMSPO once inventory is exhausted.
