Somerset Regal L4-151 2.5L (1985)
FIGURE 3
10.
Using tool J-38188-1, carefully extract the bolt from the block, see Figure 4.
IMPORTANT:
Blow debris out of bolt hole following bolt extraction.
11.
Install a new bolt as selected from the "Application Table".
IMPORTANT:
Apply engine oil (e.g. 5V-30) to bolts before installation.
12.
Using tool J-36660, torque the bolt to 30 N-m (22 ft. lb.), then rotate the bolt 60 degrees.
13.
Replace the remaining two unbroken bolts (of bolts # 2, # 3, or # 6) with new ones as selected from the "Application Table".
NOTICE:
Cylinder head bolts should be replaced one at a time. Removal of more than one head bolt at a time can cause unwanted internal
and/or external coolant loss. Internal coolant loss can contaminate oil.
14.
Repeat Step 12 when fastening the bolts.
15.
If any other head bolt is broken or needs to be replaced, a new bolt should be installed as selected from the "Application Table".
16.
Following head bolt replacement, the coolant system should be pressure tested per the Service Manual - Section 6B.
17.
If no leakage is evident, the condition has been corrected.
18.
If leakage is evident, the cylinder head gasket must be replaced. Install the appropriate gasket as shown below:
Head Gasket
VIN Engine Code
Part Number
U
10101783
