Somerset Regal L4-151 2.5L (1985)
Intake Manifold: Service and Repair
Fig. 4 Intake manifold bolt tightening sequence. 1985
Fig. 5 Intake manifold bolt tightening sequence. 1986
1.
Disconnect battery ground cable.
2.
Remove air cleaner and heat stove pipe.
3.
Disconnect PCV valve and hose from throttle body unit.
4.
Drain engine coolant, then disconnect fuel lines from manifold.
5.
Disconnect electrical connectors and throttle linkage from throttle body unit.
6.
Disconnect transaxle downshift cable and cruise control linkage, if equipped.
7.
Unfasten throttle linkage and bellcrank and position aside.
8.
Disconnect heater hose from manifold.
9.
On 1985---86 models, remove alternator bracket or upper power steering pump bracket, then the ignition coil.
