Somerset Regal L4-151 2.5L (1985)
^
List of all vehicles involved in this campaign shipped to your dealership.
^
One campaign identification label for each vehicle.
Involved vehicles have been identified by Vehicle Identification Number Computer listings. Computer listings contain the complete Vehicle
Identification Number, owner name and address data, and are furnished to the involved dealers with the campaign bulletin. Owner name and address data
furnished will enable dealers to follow up with owners involved in this campaign.
These listings may contain owner names and addresses obtained from State Motor Vehicle Registration records. The use of such motor vehicle
registration data for any other purpose is a violation of law in several states. Accordingly, you are urged to limit the use of this listing to the follow-up
necessary to complete this campaign.
OWNER NOTIFICATION
Owners of vehicles involved in this campaign will be notified by Buick Motor Division (See copy of Owner Letter included with this bulletin).
TRANSFER OF VEHICLE
If a vehicle has been transferred or sold to another location, please forward vehicle information for this vehicle to your Buick Zone Office for handling
with the proper dealer.
CHANGE OF OWNER INFORMATION
Dealers are to use the Dealer Communication System (D.C.S.) to provide Buick Motor Division with subsequent Buick owner information. By reporting
a change of owner name or address of a vehicle in campaign status over the D.C.S., the need to send in an S-866 form for that vehicle is eliminated.
Terminal input instructions are covered in the D.C.S. Manual under Section 9, page 9-J01A and B.
Technical Warranty Information & Letter
LOCATION OF TIE ROD PINCH BOLT
TECHNICAL PROCEDURE
1.
Raise vehicle on hoist.
2.
Use a torque wrench and a 13 mm socket with an extension to tighten the two (2) inner and two (2) outer tie rod pinch bolts to 55 N-m (41 ft. lbs.).
Refer to Illustration for location of tie rod pinch bolts.
3.
Lower hoist.
4.
Raise hood to install a Campaign Identification Label on the fan shroud as follows:
Each vehicle modified in accordance with the instructions outlined herein will require a Campaign Identification Label. Each label provides a space
to include the campaign number, the five (5) digit Dealer Code of the dealer performing the campaign service, and the date vehicle was
campaigned. This information may be inserted with a typewriter or ballpoint pen. When installing label, clean the surface of the fan shroud and
