Terraza AWD V6-3.5L VIN L (2006)
1. Hook the latch/lock rod to the sliding door latch.
2. Install the sliding door latch to the sliding door.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the sliding door latch screws in sequence, as shown.
Tighten the screws to 10 N.m (89 lb in).
4. Ensure the rear latch lock rod is secured into the latch rod insulator.
5. Install the sliding door water deflector. Refer to Water Deflector Replacement - Sliding Door () .
6. Install the sliding door inner trim panel. Refer to Trim Panel Replacement - Side Rear Door () .
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Acutator Control
Module - Power Sliding Door (PSD) Programming and Setup.
7. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
