buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

Brakes - Revised Park Brake Cable Replacement|Page 10789 > < Master Cylinder Bench Bleeding|Page 10783
Page 1
background image

Parking Brake Cable: Technical Service Bulletins
Brakes - Revised Park Brake Cable Replacement

Bulletin No.: 05-05-26-004

Date: December 14, 2005

SERVICE MANUAL UPDATE

Subject:
Revised Park Brake Cable Replacement - Left Rear (with IRS) and Park Brake Cable Replacement - Right Rear (with IRS)

Models:
2005-2006 Buick Terraza
2005-2006 Chevrolet Uplander
2005-2006 Pontiac Montana SV6
2005-2006 Saturn Relay

with All Wheel Drive (AWD)

This bulletin is being issued to revise the Park Brake Cable Replacement - Left Rear (With IRS) and the Park Brake Cable Replacement - Right Rear
(With IRS) procedures in the Parking Brakes sub-section of the Service Manual. Please replace the current information in the Service Manual with the
following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.

The following information about proper rear park brake cable routing and clearances has been added to the Installation procedure. Make certain this
clearance is maintained when performing the following replacement procedures:

^

Rear Brake Cables

^

Rear Suspension Knuckle

^

Rear Upper Control Arms

^

Rear Suspension Coil Spring

^

Rear Wheel Drive Shaft

^

Rear Brake Caliper

Important:

Maintain proper rear park brake cable routing and clearances. Verify that the rear park brake cables have a minimum of 10 mm and a maximum of 12
mm of clearance to the wheel drive shafts (1). Maintain this clearance using retention straps or equivalent retention (2).

Brakes - Revised Park Brake Cable Replacement|Page 10789 > < Master Cylinder Bench Bleeding|Page 10783