Terraza AWD V6-3.5L VIN L (2006)
24. Remove the CPA (3) from the RR side impact module yellow connector (3), which is located under the RR seat.
25. Disconnect the vehicle harness connector (4) from the RR side impact module connector (1).
26. Remove the CPA (3) from the RF/passenger side impact module yellow connector (3), which is located under the passenger seat.
27. Disconnect the vehicle harness connector (4) from the RF side impact module connector (1).
ENABLING PROCEDURE
1. Remove the key from the ignition.
2. When enabling the side impact module - RF proceed to step 21. If the entire SIR System needs to be enabled, then go to step 3.
3. Connect the vehicle wiring harness connector to the left seat belt retractor pretensioner.
4. Install the CPA to the left seat belt retractor pretensioner connector.
5. Install the left lower center pillar trim cover.
6. Connect the steering wheel module coil yellow connector (1).
7. Install the CPA to the steering wheel module coil connector (1), located at the base of the steering column.
8. Install the left I/P insulator panel.
