Terraza AWD V6-3.5L VIN L (2006)
Power Steering Line/Hose: Service and Repair
Power Steering Cooler Pipe/Hose Replacement
Power Steering Cooler Pipe/Hose Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right side engine splash shield.
3. Place the drain pan under the power steering pump and the power steering gear.
4. Disconnect the return hose from the cooler pipe.
5. Caution:
Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or
intermediate shaft. This damage can cause loss of steering control which could result in personal injury.
Disconnect the intermediate shaft from the steering gear.
6. Use a utility stand in order to support the frame rear.
7. Remove the rear frame bolts.
8. Use the utility stand to lower the rear of the frame for clearance.
9. Remove the power steering gear heat shield and hose clip.
10. Disconnect the cooler pipe from the steering gear.
11. Remove the cooler pipe retainer bolt/screw.
12. Remove the cooler pipe retainer.
13. Remove the cooler pipe from the frame retainers and vehicle.
Installation Procedure
