Terraza AWD V6-3.5L VIN L (2006)
3. Install the power steering hose retainer to the power steering gear.
4. Notice:
Refer to Fastener Notice.
Connect the power steering hose to the steering gear.
Tighten the fitting to 27 Nm (20 ft. lbs.).
5. Install the power steering gear hose clip.
6. Install the power steering gear heat shield.
7. Use the utility stand in order to raise the frame rear.
8. Install the frame rear bolts.
Tighten the bolts to 165 Nm (122 ft. lbs.).
9. Remove the utility stand.
10. Install the intermediate shaft to the steering gear.
11. Lower the vehicle.
12. Connect the power steering pressure hose to the pump.
Tighten the fitting to 27 Nm (20 ft. lbs.).
13. Install the drive belt.
14. Bleed the power steering system.
