Terraza AWD V6-3.5L VIN L (2006)
4. Notice:
Refer to Fastener Notice.
Align the following items:
^
The halfshaft inboard seal (1)
^
The halfshaft bar
^
The swage ring (2)
Tighten each bolt of J 41048 180 degrees at a time using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
5. Important:
Place a towel in the vise before inserting the halfshaft.
For eared clamp installation, mount the halfshaft into a vise.
6. Slide the tripot seal (7) to the corresponding groove on the halfshaft bar.
7. Crimp the eared clamp (6) using J 35910, a torque wrench (8), and a breaker bar (9).
