Terraza AWD V6-3.5L VIN L (2006)
10. Measure the rotating torque of the driven shaft in both directions.
11. When reusing drivenshaft bearings, the rotating torque should equal the value recorded during disassembly.
A properly assembled shaft and NEW bearings should have a rotating torque of 1.5 Nm (13 inch lbs.).
12. Reinstall J 44755 to tighten the flange nut as required to achieve the proper rotating torque value. Do NOT loosen the flange nut to achieve the
proper torque or a NEW spacer must be installed.
13. Apply sealant GM P/N 12346004 (Canadian P/N 10953480), or equivalent to both sides of the shim.
14. Align the reference marks and install the shim (2) to the transfer case.
15. Install the extension housing (1) and bolts (3) to the shim and transfer case.
Tighten the extension housing bolts to 32 Nm (24 ft. lbs.).
16. Install the extension housing drain plug (1) and gasket to the extension housing.
Tighten the plug to 32 Nm (24 inch lbs.).
17. Remove the extension housing fill plug (2) and gasket.
18. Fill the extension housing with gear oil. Refer to Transfer Case Fluid Replacement.
19. Install the extension housing fill plug and gasket.
Tighten the plug to 28 Nm (21 inch lbs.).
