Terraza FWD V6-3.5L VIN 8 (2005)
6. Position the sliding door center roller bracket (2) to the rear of the track or until the pin holes are aligned.
7. Install the pin (1) to the sliding door center roller bracket.
8. Remove the support from the power sliding door.
Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be
operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer toAcutator Control Module
- Power Sliding Door (PSD) Programming and Setup .
9. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.
10. Manually open and close the rear sliding door in order to verify the door fit and the door latch/unlatch operation.
11. Test the cable tension again after manually moving the door.
