Terraza FWD V6-3.5L VIN 8 (2005)
2. Install the sliding door outside handle to the sliding door.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the sliding door outside handle nuts.
Tighten the nuts to 10 N.m (89 lb in).
4. Install the outside handle cable to the lock assembly.
5. Install the lock assembly to the sliding door.
6. Install the sliding door handle lock actuator screws.
Tighten the screws to 10 N.m (89 lb in).
7. Install the sliding door lock module harness connector, if the door is equipped with one.
8. Push the lock rod towards the sliding door lock assembly and snap the barrel nut into the lock assembly.
9. Install the control rods to the sliding door outside handle.
10. Check for proper lock rod travel.
11. Install the sliding door water deflector. Refer to Water Deflector Replacement - Sliding Door (See: Sliding Door Interior Trim Panel/Service and
Repair/Water Deflector Replacement - Sliding Door) .
12. Install the sliding door inner trim panel. Refer to Trim Panel Replacement - Side Rear Door () .
