buick Workshop Repair Guides

Buick Workshop Service and Repair Manuals

06-08-111-004B|Page 14364 > < 06-08-111-004B|Page 14362
Page 3
background image

There is windnoise from around the top of the front doors.

Cause

The primary seal might not be making good contact to the door surface. Check the seal contact with the dollar bill method.

Correction

Pull the primary seal down and measure the distance between the door surface and the body. Refer to the illustration above. Adjust the door striker to
achieve 15 mm (9/16 in) between the door and the hem flange.

Condition # 4

There is windnoise from the sliding side door.

Cause

The sliding side door may be outboard of the front door.

Correction

Adjust the sliding side door inboard 1 mm of the front door.

Condition # 5

There is windnoise from the sliding side door glass.

Cause

There may be a gap in the sliding side door glass urethane.

Correction

Clean the leak area and reseal with urethane.

Condition # 6

There is a windrush from the sliding side door glass.

Cause

The sliding side door glass is sticking outboard from the sliding side door outer sheet metal too far.

Correction

Tape off the glass to verify. If that corrects the condition, it will be necessary to remove the glass and reset it in the opening.

Condition # 7

06-08-111-004B|Page 14364 > < 06-08-111-004B|Page 14362