Terraza FWD V6-3.5L VIN 8 (2005)
1. Ensure the 2 retainers in the lower body side molding (2) are secured to the new molding.
Important:
*
Do NOT touch the exposed adhesive tape with your hands.
*
Do NOT allow the exposed adhesive tape to collect any dirt or foreign material.
2. Use aJ 25070 to warm the door to a minimum of 21°C (70°F).
Important: Do not touch the adhesive backing on the molding.
3. Remove the protective liner (1) from the back side of the molding (2).
4. Insert the retainer into the holes starting with the rear hole (3).
5. Align the front retainer to the door second.
6. Wet-out the molding in order to ensure a maximum bond to the door.
