Terraza FWD V6-3.5L VIN 8 (2005)
1. Hold the cylinder (9) so that the side with four tumbler spring wells faces up.
IMPORTANT: The ignition lock cylinder tumblers (2) are not self retaining and must be held in place if the key is not fully inserted into the lock
cylinder, or the tumbler retainer (1) is properly staked into the cylinder.
2. Insert tumbler springs (3) into the five spring wells.
3. The first tumbler to be loaded will be the 1st key cut position (the first number in the key code). Install the first tumbler (2) in the slot nearest the
front of the lock cylinder, this is the side into which the key would be inserted. It may be necessary to move the sidebar (4) out slightly to fully
install the tumbler (2).
4. Install the four remaining tumblers on this side of the lock cylinder, key cut positions 3, 5, 7 and 9.
5. Inspect for correct loading of the tumblers (2) by inserting the key into cylinder (5). The sidebar (4) should be flush with the outside diameter of
the cylinder (5).
6. Turn the cylinder (5) so that the side with the four tumbler spring wells is facing up. Remove the key.
7. Insert the tumbler springs (3) into the four spring wells.
8. Install the tumbler (2) for the key cut position 2 into the slot nearest to the front of the lock cylinder.
9. Install the three remaining tumblers, key cut positions 4, 6 and 8, on this side of the lock cylinder.
10. Inspect for correct loading of the tumblers (2) by inserting the key into cylinder (5). The sidebar (4) should be flush with the outside diameter of
the cylinder (5).
11. Lightly lubricate the tumbler (2) surfaces using the provided lubrication.
12. With the key inserted into the housing, install and carefully stake one tumbler retainer (1) into the recessed area (2) on the cylinder.
13. Turn over the cylinder and carefully stake the other tumbler retainer (1) into the recessed area (2) on the cylinder.
ASSEMBLING AND CODING DOOR LOCK CYLINDER
The front side door lock cylinder only uses seven of the ten cut positions, 4-10. The tumbler positions are staggered from side to side (4 on one side
and 3 on the other). The left and right door lock cylinders are identical. The lock pawl determines which side of the vehicle the lock cylinder is on.
1. Hold the cylinder (9) so that the side with four tumbler spring wells faces up.
IMPORTANT: The front side door lock cylinder tumblers (10) are not self retaining and must be held in place if the key is not fully inserted into the
lock cylinder, or until the cylinder (9) is assembled into the case assembly (11).
2. Insert tumbler springs (5) into the four spring wells.
3. Install the tumbler for key cut position 4 in the slot nearest to the front of the lock cylinder.
4. Install the three remaining tumblers, key cut positions 6, 8 and 10, on this side of the lock cylinder.
5. Inspect for correct loading of the tumblers (10) by inserting the key into cylinder (9). All of the tumblers should be flush with the outside diameter
