Terraza FWD V6-3.5L VIN 8 (2005)
Air Bag(s) Arming and Disarming: Service and Repair
SIR Disabling and Enabling Zone 9
SIR DISABLING AND ENABLING ZONE 9
DISABLING PROCEDURE
IMPORTANT: Refer to SIR Service Precautions.
1. Turn the steering wheel so that the vehicles wheels are pointing straight ahead.
2. Turn OFF the ignition.
3. Remove the key from the ignition switch.
4. Open the hood and locate the underhood fuse center.
5. Lift the cover for the underhood fuse center.
6. Locate and remove the air bag fuse from the underhood fuse center.
IMPORTANT: With the Air Bag Fuse removed and the ignition ON, the AIR BAG indicator illuminates. This is normal operation, and does not
indicate an SIR system malfunction.
7. When only disabling only side impact module - RF proceed to step 21, if the entire SIR system needs to be disable then go to step 7.
8. Remove the driver/left lower center pillar trim cover.
9. Remove the connector position assurance (CPA) from the driver/left seat belt retractor pretensioner connector.
10. Remove the vehicle wiring harness connector from the left seat belt retractor pretensioner.
11. Remove the driver/left I/P insulator panel.
12. Remove the CPA from the steering wheel module coil yellow connector (1) located at the base of the steering column.
13. Disconnect the steering wheel module coil connector (1).
