Terraza FWD V6-3.5L VIN 8 (2005)
Brake Pedal Assy: Service and Repair
Brake Pedal Assembly Replacement
Removal Procedure
1. Remove the left side insulator pane.
2. Remove the knee bolster.
3. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
4. Disconnect the electrical connector from the stop lamp switch.
5. Remove the booster push rod retain clip and washer (2) from the brake pedal assembly.
6. Remove the accelerator pedal.
7. Remove the booster push rod (2) from the brake pedal (1).
8. Remove the brake booster mounting nuts (3).
9. Remove the digital radio receiver and bracket if equipped.
10. Remove the brake pedal brace (4) mounting nuts (1).
11. Remove the brake pedal brace (4) mounting bolt.
12. Remove the brake pedal assembly mounting nuts (2).
13. Pull master cylinder and brake booster assembly forward for additional clearance while removing brake pedal assembly.
14. Remove the brake pedal assembly with the bracket (4).
15. Remove the brake pedal assembly (3) from the vehicle.
16. Remove the brake pedal position sensor from the brake pedal assembly.
Installation Procedure
1. Install the brake pedal position sensor to the brake pedal assembly.