Terraza FWD V6-3.5L VIN 8 (2005)
20. Select the appropriate forming mandrel and place into the forming ram.
21. Rotate the hydraulic fluid control valve clockwise to the closed position.
22. Rotate the body of the J 45405 until it bottoms against the die cage.
23. While guiding the forming mandrel into the exposed end of pipe to be flared, operate the lever of the J 45405 until the forming mandrel bottoms
against the clamping dies.
24. Rotate the hydraulic fluid control valve counterclockwise to the open position to allow the hydraulic forming ram to retract.
25. Loosen the die clamping screw and remove the dies and pipe.
26. If necessary, lightly tap the dies until the die halves separate.
27. Inspect the brake pipe flare for correct shape and diameter (a).
7.10 mm (0.279 inch) 0.18 mm (0.007 inch) flare diameter for 4.76 mm (3/16 inch) diameter pipe
28. If necessary, using the removed section of pipe as a template, shape the new pipe with a suitable brake pipe bending tool.
Important: When installing the pipe, maintain a clearance of 19 mm (3/4 inch) from all moving or vibrating components.
29. Install the pipe to the vehicle with the appropriate brake pipe unions as required.
30. If previously released, secure the brake pipe to the retainers.
31. Bleed the hydraulic brake system.
32. With the aid of an assistant, inspect the brake pipe flares for leaks by starting the engine and applying the brakes.
